Product

Front Forward Upper & Lower Control Arms Polaris Ranger XP 1000

$476.95

Quick Info SKU: MCFLA-RZR9-B Category:

Description

High Lifter’s service team uses a hydraulic press to install the ball joint with the correct pressure and alignment, also making sure the clip is fully seated and secured. Purchasing control arms with the ball joints already installed prevents damage due to improper installation, which is not covered by High Lifter’s Lifetime Warranty.
The ball joints preinstalled in this kit are BJP-3 and BJP-5.
Our arms maximize ground clearance by strategically arching the lower control arms while following the angle of the axle for maximum clearance, axle protection, and visual appeal. Don’t be fooled with too much arch that puts your axles into greater risk of damage. Our precision manufacturing process ensures each control arm installs exactly like the factory arm. Depending on the model, most kits will have the High Lifter logo precision cut into the bracing.
Installation is made easy with our step by step and multi-image instructions. During installation, you can use stock bushings and ball joints for easy installation. Even better, High Lifter will install your ball joints before shipping. (See our control arms with preinstalled ball joints.) Always check for bearings, bushings, ball joints, and brake wear before installation and replace if needed. We always recommend checking these parts before you start your installation to save time and get back on the trail sooner. See the Replacement Parts Tab to purchase replacement parts as needed.
Features:
25% larger than average stock arms – Crafted from 1 ¼” DOM steel
Up to 2.5x the wall thickness of an average stock arms – .188” wall thickness
Grease fittings included for most models
Added ground clearance featuring bends that maximize clearance and axle protection
Most stock powder coat colors available in stock
Easy to install and maintain
Limited Lifetime Warranty
Tire Fitment:
Up to 31”
Our tire fitment guide is a general fitment and is in no way guaranteed. Tires and lifts vary by manufacture and tire fitment can be affected by other modifications such as, but not limited to, wheel offset, actual tire diameter and actual tire width. Always verify your brand of tires, lift, and other modifications prior to making a buying decision.
Note: If a customer is running or plans on running Front Outlaw DHT Axles and this forward a-arm kit, they will need to add the Polaris Steering Stop Kit (Part# RANGER-SSK) to avoid clearance issues on the CV boot.
Note: Be sure to check for worn ball joints, bearings, and bushings before installation and replace them if needed. If ball joints are needed, see part number BJP-3 and BJP-5; for bearings, see part number WBK-25-1628; for lower control arm bushings, see part number BK-50-1076.
Note: If a customer is running or will purchase the forward control arms and wants to run it with BUMPER-RNG9 (or any similar bumper), the bumper will have to be modified/cut/trimmed to clear any tire 28″ or taller.

Reviews

There are no reviews yet.

Be the first to review “Front Forward Upper & Lower Control Arms Polaris Ranger XP 1000”

Your email address will not be published. Required fields are marked *

GRANDPRIX

Lorem ipsum dolor sit amet, qui aperiam vituperatoribus at. Aliquip percipit ei vix, ceteros mentitum reprehendunt eu est.

instagram

QUICK INFO

Monday-Friday: 9am to 5pm; Satuday: 10am to 2pm
7300-7398 Colonial Rd, Brooklyn 242 Wythe Ave #4, Brooklyn
+ (123) 124-567-8901 + (123) 124-567-8901
[email protected] [email protected]